The jetting behaviour classifies into four regimes: regular jet, splitting (hourglass), needle-jet (thin, high-speed jet), and detachment (bubble lift-off) as a function of stand-off γ and wall-jet velocity v_jet .
Increasing v_jet shifts needle-jet and detachment regimes to larger γ compared with stagnant liquid, e.g. needle-jet appears up to γ≈0.8 for v_jet≈5 m/s whereas in quiescent liquid it requires γ≲0.2 .
Wall stresses and pressures — large amplification of shear with moderate pressure increase
Example (γ≈1.5): adding v_jet=5 m/s transforms collapse: needle-like axial jet velocity increases ~3× (to ≈300 m/s) and peak wall shear jumps from ~94 kPa (stagnant) to ~306 kPa while peak wall pressure rises from ~2.3 MPa to ~9.3 MPa .
Intermediate and small γ cases show even larger shear: needle jets at γ≈0.7–0.4 generate peak wall shear up to ~2764 kPa and wall pressure up to ~49 MPa in simulations .
Small stand-off (detachment) — lift-off and safer collapse away from wall
For small γ (≈0.4–0.5) and sufficiently large v_jet (≈5 m/s), converging planar flow can lift the bubble off the wall so the violent collapse occurs ≈120 μm away from the wall, reducing direct solid contact and potential erosion despite high wall shear events from subsequent jets .
Simulated peak values in this regime: τ_w,max ≈ 1.9×10^6 Pa and p_w,max ≈ 86 MPa (mesh-dependent — values are lower bounds due to axisymmetry and resolution limits) .
Numerical approach & validation notes
Fully coupled implicit finite-volume compressible two-phase (algebraic VOF) simulations with NASG EOS, neglecting surface tension for viscous/inertia-dominated cases; mesh refined to Δx0=1 μm in core, cell centers as close as 12.5 nm from wall .
Mesh convergence shows peak shear/pressure increase with refinement; reported maxima should be interpreted as mesh- and 2D-axisymmetric-limited lower bounds .
Practical implications and controllability
By adjusting v_jet and γ one can tailor bubble–wall interaction: maximize wall shear (for cleaning) while avoiding erosive collapse at the wall via detachment—practical for cleaning, peening, or damage mitigation applications .
思维导图
深度阅读
以下为对“Single cavitation bubble dynamics in a stagnation flow”一文的逐节、图表与方法的深入解构与批判性分析。为便于溯源,文中引用自原文的结论或推断均在句末标注了页码标识 [page::页码](若一处信息源自多页,按要求最多列出两页)。我尽量遵循原文结构逐节分析,并对所有主要图表逐一解读与关联文本论点;最后给出审慎性点评与综合结论。
一、元数据与总体概览(引言与报告概览)
报告题目与作者:论文题为 “Single cavitation bubble dynamics in a stagnation flow”,作者 Dominik Mnich, Fabian Reuter, Fabian Denner, Claus‑Dieter Ohl,机构包括 Otto‑von‑Guericke‑University Magdeburg 和 Polytechnique Montréal,投稿/接收时间见页面页眉(Received 14 July 2023; revised/accepted 6 December 2023)。